Specifies the group IP address, which is used for group administration and host access to volumes.
If you modify the group IP address and the group is configured as a replication partner, be sure the replication partner is notified of the change. In other words, be sure the IP address stored on the replication partner is changed to match the new group IP address.
Note: Modifying the group IP address will disconnect group management sessions and iSCSI discovery sessions. If you modify the group IP address and initiators are configured statically with the group IP address, you may need to update the iSCSI initiators with the new information. However, if initiators are finding targets dynamically (for example, through iSNS), they should be able to rediscover the targets.
You must have network connectivity between the system running the initiator and the subnet containing the group IP address to perform discovery and log in to a target.
Format
grpparams group-ipaddress ip_address
Variable
|
ip_address |
Group IP address. |
Example
The following command modifies the IP address for the group:
> grpparams group-ipaddress 10.12.13.144