Selects a partner and confirms that all the transfer files created for a volume using manual transfer replication have been loaded to the replica placeholder (only with the Manual Transfer Utility CLI).
Run this command only on the secondary group, specifying the primary group and the inbound replica set that represents the replica placeholder, after loading the transfer files to the replica.
The primary group periodically polls the secondary group to check the status of replication transfers. This command sends a confirmation status back to the primary group and changes the volume and replica status on both groups.
Format
partner select partner_name inbound-replicaset select set_name
first-manual-xfer done
Variables
|
partner_name |
Group name of the primary group (where the replicated volume is located). |
|
set_name |
Name of an inbound replica set that represents the replica placeholder. |
Example
The following example confirms the completion of a manual transfer replication for a volume that originated on group2:
> partner select group2 inbound-replicaset select emailvol
first-manual-xfer done