Running Array Management Commands

There are two ways to access an array and run array management commands:

• If a network connection is available, you can use telnet or SSH to connect to an array through an IP address assigned to a network interface on the array (for example, eth0). Do not connect to the group IP address.
• Use the null modem cable (or cables) shipped with the array to connect Serial Port 0 on the active control module to a console or a computer running a terminal emulator. (The active control module’s ACT LED is green.) The following serial connection characteristics are required for CLI access:
• 9600 baud
• One STOP bit
• No parity
• 8 data bits
• No hardware flow control